Srx550 Services Gateway Supported Ac Power Cords - Juniper SRX550 Hardware Manual

RELATED DOCUMENTATION
General Site Installation Guidelines for the SRX550 Services Gateway | 35
Maintaining the SRX550 Services Gateway Power Supply | 123
SRX550 Services Gateway Power Requirements | 54
SRX550 Services Gateway Environmental Specifications | 36

SRX550 Services Gateway Supported AC Power Cords

WARNING:
services gateway only and not for any other use.
NOTE: In North America, AC power cords must not exceed 4.5 m (approximately 14.75 ft) in
length, to comply with National Electrical code (NEC) Section 400-8 (NFPA 75, 5-2.2) and 210-52,
and Canadian Electrical Code (CEC) Section 4-010(3).
Table 15 on page 51 provides power cord specifications, and
the AC power cord provided for each country or region.
Table 15: AC Power Cord Specifications
Country
Australia
China
Europe (except Italy and United Kingdom)
Italy
Japan
North America
The AC power cord for the services gateway is intended for use with the
Electrical Specification
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
125 VAC, 12 A, 50 or 60
Hz
125 VAC, 10 A, 60 Hz
Figure 13 on page 52 depicts the plug on
Plug Standards
AS/NZ 3112-1993
GB2099.1 1996 and
GB 1002 1996
(CH1-10P)
CEE (7) VII
CEI 23-16/VII
JIS 8303
NEMA 5-15
51