Figure 48
1. Reel-speed control
Note:
You can increase or decrease the reel
speed to compensate for turf conditions.
Backlapping the Reels
WARNING
Contact with the reels or other moving parts
can result in personal injury.
• Keep your fingers, hands, and clothing
away from the reels or other moving parts.
• Never attempt to turn the reels by hand or
foot while the engine is running.
1.
Position the machine on a level surface, lower
the cutting units, shut off the engine, and engage
the parking brake.
2.
Remove the plastic cover to the left side of the
g014623
seat.
3.
Make initial reel to bedknife adjustments
appropriate for backlapping on all cutting units
which are to be backlapped; refer to the Cutting
Unit Operator's Manual.
DANGER
Changing the engine speed while
backlapping may cause the reels to stall.
• Never change the engine speed while
backlapping.
• Backlap only at idle engine speed.
4.
Start the engine and run at low idle speed.
5.
Rotate the backlap lever to the R
position
(Figure
1. Backlap lever—F
position
6.
Rotate the reel-speed control to setting 1
50).
43
EVERSE
49).
Figure 49
2. Backlap lever—R
ORWARD
position
(R)
g014620
EVERSE
(Figure