Adjusting The Transport Speed - Toro Greensmaster TriFlex 3400 Operator's Manual

Figure 32
1. Eccentric
B. Move the functional-control lever to the
N position and the throttle to the
EUTRAL
S position. Start the engine.
LOW
C. Rotate the eccentric until creep does not
occur in either direction. When the wheel
stops rotating, tighten the nut locking the
eccentric and the adjustment
Verify the adjustment with the throttle in the
S and F
LOW AST
Note:
If the wheel still turns when the
eccentric is at the maximum adjustment,
contact your Authorized Service Distributor
or refer to the Service Manual for further
adjustment.
Adjusting the Transport
Speed
Obtaining the Maximum Transport
Speed
The traction pedal is adjusted for maximum-transport
speed at the factory, but you may need to adjust it
if the pedal reaches full stroke before it contacts the
pedal stop, or if you want to a decrease the transport
speed.
To obtain the maximum-transport speed, put the
functional control lever in the T
press down on the traction pedal. If the pedal contacts
the stop (Figure 33) before you feel tension on the
cable, perform the following adjustment procedure:
2. Locknut
(Figure 32).
position.
position and
RANSPORT
g014616
1. Pedal stop
1. Put the functional-control lever in the T
position and loosen the locknut securing the
pedal stop to the floor plate
2. Tighten the pedal stop until it does not contact
the traction pedal.
3. Continue applying a light load on the transport
pedal and adjust the pedal stop so it contacts
the pedal rod and tighten the nuts.
Important:
cable is not excessive or you will reduce the
cable life.
Reducing the Transport Speed
1. Press down on the traction pedal and loosen the
locknut securing the pedal stop to the floor plate.
2. Loosen the pedal stop until you obtain the
desired transport speed.
3. Tighten the locknut securing the pedal stop.
34
Figure 33
(Figure
Ensure that the tension on the
g015494
RANSPORT
33).