Installing The Oil Cooler (Optional); Installing The Grass-Basket Hooks - Toro 04520 Operator's Manual

Important: Failure to correctly activate the
battery may result in battery gassing and/or
premature battery failure.
7. Install the vent caps.
8. Place the battery on the battery tray and secure it with
the battery clamp and fasteners removed previously.
9. Install the positive cable (red) to the positive (+)
terminal and then the negative cable (black) to the
negative (–) terminal of the battery and secure them
with the bolts and nuts
boot over the positive terminal to prevent a possible
short from occurring.
WARNING
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can cause
the battery gasses to explode, resulting in personal
injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always connect the positive (red) battery cable
before connecting the negative (black) cable.
1. Negative (-)
2. Positive (+)
5
Installing the Oil Cooler
(optional)
No Parts Required
Procedure
If you are operating the machine in hot climates, where the
ambient temperature is above 29°C (85°F), or using it for
(Figure 7). Slide the rubber
Figure 7
heavy-duty use (mowing other than greens, such as fairways
or verticutting), install a Hydraulic Oil Cooler Kit, Part No.
119-1691.
6
Installing the Grass-Basket
Hooks
Parts needed for this procedure:
6 Grass-basket hook
12 Flange bolts
Procedure
Install the 6 grass-basket hooks onto the ends of the
suspension-arm bars using the 12 flange bolts
1. Flange bolt
2. Grass-basket hook
14
(Figure
Figure 8
3. Suspension-arm bar
8).