Installing The Optional Oil Cooler; Installing The Grass Basket Hooks; Installing The Cutting Units - Toro 04530 Operator's Manual

5
Installing the Optional Oil
Cooler
No Parts Required
Procedure
If you are operating the machine in hot climates, where the
ambient temperature is above 29° C (85° F), or using it for
heavy-duty use (mowing other than greens, such as fairways
or verticutting), install a Hydraulic Oil Cooler Kit, Part No.
119-1691, to the machine.
6
Installing the Grass Basket
Hooks
Parts needed for this procedure:
6 Grass basket hook
12 Flange bolts
Procedure
Install the 6 grass basket hooks onto the ends of the
suspension arm bars using 12 flange bolts (Figure 9).
1. Flange bolt
2. Grass basket hook
Figure 9
3. Suspension arm bar
7

Installing the Cutting Units

Parts needed for this procedure:
1 Gauge bar
3 Cutting unit (model 04613, 04614, or 04615)
3 Cutting unit upper weight
6 Hex head screws
3 Grass Basket
Procedure
Note: When sharpening, setting the height-of-cut, or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the storage location
on the front of the suspension arms to prevent damage to
them.
Important: Do not raise the suspension to the transport
position when the reel motors are in the holders in the
machine frame. Damage to the motors or hoses could
result.
Important: Whenever the cutting unit has to be tipped
to expose bedknife/reel, prop up rear of cutting unit to
make sure nuts on back end of bedbar adjusting screws
are not resting on work surface (Figure 10).
g014596
1. Prop (not provided)
Note: All cutting units are shipped with the counter weight
mounted to the right end and the motor mount and drive
coupler mounted to the left end of the cutting unit.
1. Disconnect the cutting unit power disconnect couplers;
refer to Cutting Unit Power Disconnect (page 25).
15
2
2
1
Figure 10
2. Bedknife adjusting screw
nut (2)