7.CVT Continuously Variable Transmission
UXV 500i/700i
Slide the movable drive face of the drive pulley onto the drive pulley shaft. Grasp the upper
and lower runs of the belt together between the drive and driven pulleys to allow for extra
slack in the belt as it sits on the drive pulley faces. Adjust the position of the belt so that
when the drive pulley nut is tighten the belt will not be pinched.
Caution: If the belt is sitting too low in the drive pulley it can be pinched when the nut is
tightened. This creates an improper torque reading for the nut and can cause damage to
the engine if it is run with an improperly installed belt.
7-102