KYMCO UXV500I Repair Manual page 1015

6.Cooling System
Place the fail motor switch in oil contained in a pan as shown and raise the oil temperature
gradually to check for the temperature at which the switch starts operates. Do not allow the
switch or the thermometer to contact the container. If the switch operating temperature is
not within the specified range, replace the switch with a new one.
OFF to ON
ON to OFF
To inspect the water temperature sensor (WTS) see the
UXV 500i/700i
Over 88 - 92° C
Below 88 - 92° C
Fuel Injection Sensors
6-30
topic.