KYMCO UXV500I Repair Manual page 1124

7.CVT Continuously Variable Transmission UXV 500i/700i
CVT Installation
SAFETY FIRST: Protective gloves and eyewear are recommended at this point.
Driven Pulley
Install a new O-rings and dust seals into the movable face of the driven pulley. Drive in the
new seals with a suitable driver with the same outside diameter as the seal. Coat the
O-rings, seals, and inside of the movable face where it rides on the fixed face with grease.
Fit the movable driven face onto the fixed driven face. Wipe away any grease that gets on
the faces where the belt will ride.
7-88