Hard Drive - HP Notebook 14 Maintenance And Service Manual

Before removing the optical drive dummy, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the base enclosure (see
components:
▲ Battery (see
Remove the optical drive dummy:
▲ Remove 1 screw (1), and then remove the optical drive dummy (2).
Reverse this procedure to install the optical drive dummy.

Hard drive

Description
Hard drive, SATA 500 GB 5400 RPM 7MM
IMPORTANT:
and replacement.
Before removing the hard drive, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
Base enclosure on page
Battery on page
Make special note of each screw and screw lock size and location during removal
20), and then remove the following
22).
Spare part number
683839-855
Component replacement procedures 23