Wlan Cable - HP Notebook 14 Maintenance And Service Manual

WLAN cable

Description
WLAN cable
IMPORTANT:
and replacement.
Before removing the WLAN cable, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the base enclosure (see
components:
a. Battery (see
b. Optical drive dummy (see
c. Hard drive (see
d. Memory (see
e. WLAN module (see
f. Heat sink and fan (see
g. Speakers (see
h. Microphone (see
i. System board(see
Remove the WLAN cable:
▲ Disconnect the WLAN antenna from the WLAN module(1), release the WLAN cable from the tape
securing it (2), and then lift the cable to remove it (3).
Make special note of each screw and screw lock size and location during removal
Base enclosure on page
Battery on page
Optical drive dummy on page
Hard drive on page
Memory on page
WLAN module on page
Heat sink and fan on page
Speakers on page
Microphone on page
System board on page
20), and then remove the following
22).
23).
25).
28).
30).
32).
34).
36).
Spare part number
792505-855
22).
Component replacement procedures 39