Panasonic Inverter R32 Series Technical Data & Service Manual page 185

1
HOW TO INSTALL THE INDOOR UNIT
Required Minimum Space for Installation and Service
(1) Dimensions of suspension bolt pitch and unit
Length
Type
60, 71
100, 125, 140
(2) Refrigerant tubing • drain hose position
Left side
267
(3) Unit opening position (Refrigerant tubing • drain hose • power inlet port • remote control wiring inlet port)
Left-side drain hose
outlet port
*1
*1
120
90
A B
1226 1275
1541 1590
Rear (Figure shows view from front)
90
Left drain position
Left drain position
Closed with rubber stopper
at time of shipment.
Rear outlet port (Figure shows view from front)
Remote control wiring
and inter-unit wiring inlet port
Outside air intake duct
connection port
(ø100, cutout)
Left-rear side drain
hose outlet port
(cutout)
Power inlet port
C
235
235
Unit: mm
24.5
70 86
Gas tubing
Liquid tubing
90
Right drain position
Top outlet port
88
*2
123 61
123
*1 Use a compass saw, jigsaw or similar tool and cut along
the indented portion of the side cover and make a hole
inside the cover.
*2 When removing the refrigerant tubing from the upper
side, cut along the indented portion and pass the tubing
through the hole.
Be sure to use sealing putty to seal off the opening to
prevent dust.
Cover of tubing hole
1-11-84
B
A
24.5
(Suspension bolt pitch)
Right side
216
(Liquid tubing •
Gas tubing)
267
Right drain position
Right-side drain
hose outlet port
Side cover
N OTE
Unit: mm
C
Air intake
Air discharge
Unit: mm
187
Unit: mm
*1
*1