Panasonic Inverter R32 Series Technical Data & Service Manual page 126

If there are obstacles above the unit
1 For separate installation location
• The dimensions for H, A and L are shown in the following table.
L
0 < L 1
L H
1/2H < L
H < L Install a pedestal or mount so that L
• Cover the bottom part of the pedestal or mount so that air does not go through it.
Pattern 2 If there is an obstacle that is higher than the unit on the discharge side. (There is no limit to the height of the obstacle above the discharge.)
If the upper part is open
1 For separate installation location
If there are obstacles above the unit
1 For separate installation location
• The dimensions for H, A and L are shown in the following table.
L H
H < L Install a pedestal or mount so that L
• Cover the bottom part of the pedestal or mount so that air does not go through it.
(D) Stacking installation setup
• Stack up to 2 tiers.
• A dimension of approximately 400 mm is required for the second tier outdoor unit's drain pipe and space for maintenance of the fi rst tier outdoor unit.
• Close A section (the space between the upper and lower level outdoor units) so the outtake air does not bypass it.
1 If there are obstacles at the discharge
A section
(E) For multiple row installation (on the roof, etc.)
1 For one row installation setup
• The dimensions for H, A and L are shown in the following table.
L H
H < L
• The above mentioned distance is required for optimal unit performance.
Allow as much space as possible in order to obtain the best performance from the units.
A
2 / H 5 0 0
H 7 5 0
H
A
1 0 0
H
A
3 0 0
n I t s l l a t a o i n n t o p o s s b i e l
2 For multiple units (up to 2 units)
• The dimensions for H, A and L are shown in the following table.
L H
H < L
• Cover the bottom part of the pedestal or mount so that air does not bypass it.
• A limit of only 2 units can be installed.
2 For multiple units (more than 2 units)
2 For multiple units (up to 2 units)
• The dimensions for H, A and L are shown in the following table.
L H
H < L
• Cover the bottom part of the pedestal or mount so that air does not bypass it.
• A limit of only 2 units can be installed.
2 If there are obstacles at the intake
A section
2 For multiple units (more than 2 units)
1-11-25
L A
0 < L 1 2 / H 1 0 0 0
1/2H < L H 1 2 5 0
Install a pedestal or mount so that L H
A
4 0 0
Install a pedestal or mount so that L H
1