Polaris MATRIX INDY VR1 Series Owner's Manual page 39

TOOLS
The belt removal L-wrench tool, spare belt, spark plug, and spark plug tool
container are located behind the left engine compartment panel.
Spare belt and spark plugs are not provided with the snowmobile.
L-WRENCH
When properly engaged in the bracket,
q
the L-wrench
the console. To retrieve the L-wrench,
rotate it counter-clockwise and slide it
upward from the bracket. Return the L-
wrench to the bracket and rotate it
clockwise when it's not in use.
SPARK PLUG WRENCH
The spark plug wrench secures the spare belt/spark plug tool container to the
front bumper. Remove the container to add or access a spare spark plug or belt.
REPLACEMENT DRIVE BELT
To insert a replacement drive belt into the spare drive belt container, do the
following:
1. Rotate the spark plug wrench counter-clockwise to release it from the
bracket.
2. Pull the wrench upward to remove it.
3. Tilt the container until the bracket detaches from the bumper tube.
4. Pull the container out of the compartment.
5. When placing a drive belt into the container, fold the belt as shown. Verify
that the belt loop at the rear of the container is positioned slightly higher than
the front loop.
6. Slide the container into the engine compartment at an angle.
7. Position the container bracket onto the bumper tube and rotate it downward.
8. Reinstall the spark plug wrench into the bracket and through the hole in the
bumper tube.
9. Rotate the spark plug wrench clockwise until it locks into place.
secures the fender to
NOTICE
FEATURES
37