Polaris MATRIX INDY VR1 Series Owner's Manual page 147

DISENGAGING REVERSE
1. Stop the snowmobile and leave the engine idling.
Engaging the starter when the engine is running WILL result in serious engine
damage, especially if the engine is in reverse. Never engage the starter when
2. Push the yellow reverse button for one second and release. The engine will
slow and begin to rotate forward. The light on the instrument panel will shut
off.
3. Apply the throttle slowly to make sure the vehicle is in forward.
EMERGENCY STOPPING
The following chart lists methods for stopping the snowmobile in the event of an
emergency.
SYSTEM
Ignition Switch
Brake
Engine Stop Switch
Throttle Safety Switch
Tether Switch (Option)
DAILY STORAGE
At the end of each ride, park the snowmobile on a level surface and support it at
the rear with an appropriate track stand. The track should be suspended
approximately 4 inches (10 cm) off the ground.
Remove the key and cover the snowmobile.
TOWING
For your safety, do not attempt to use a tow hitch until you've read the following
warnings and understand the proper hitch functions.
CAUTION
the engine is running.
Interrupts ignition circuit
Slows jackshaft
Interrupts ignition circuit
Interrupts ignition circuit
Interrupts ignition circuit
OPERATION
WHAT IT DOES
145