Polaris MATRIX INDY VR1 Series Owner's Manual page 207

DIAGNOSTIC TROUBLE CODES (DTCS) – MATRYX
SPN = SUSPECT PARAMETER NUMBER / FMI = FAILURE MODE INDICATOR
TROUBLE CODE
PTO Cylinder Port
Injector Open
Circuit
Ignition Coil 1
(MAG) Driver
Circuit Open
Ignition Coil 2
(PTO) Driver Circuit
Open
Max. Detonation
Correction Limit
Reached, MAG
Cylinder
Cylinder 1 (MAG)
Knock Level Critical
Max. Detonation
Correction Limit
Reached, PTO
Cylinder
Cylinder 2 (PTO)
Knock Level Critical
Sensor Supply
Voltage 1 Low
DIAGNOSTIC TROUBLE CODES (DTC)
SPN FMI
652 5
1268 5
1269 5
1352 0
1352 16
1353 0
1353 16
3509 4
P-
CODE
P0264 This Trouble Code sets if an Open Circuit
Condition is detected in the PTO Cylinder
Port Injector Control Circuit. Can be
caused by Damaged Wiring, a faulty Fuel
Injector or ECU / Connections.
P1351 This Trouble Code Sets if Ignition Coil 1
(MAG) Driver Circuit is Open. Can be
caused by Damaged Wiring/Connections,
a Faulty MAG Ignition Coil or ECU.
P1352 This Trouble Code Sets if Ignition Coil 2
(PTO) Driver Circuit is Open. Can be
caused by Damaged Wiring/Connections,
a Faulty PTO Ignition Coil or ECU.
P1336 This Trouble Code Sets if the Engine
Controller Reaches the Maximum
Detonation Control Limit by Fuel
Correction on the Mag Cylinder Can be
caused by Incorrect Fuel (low octane or
Ethanol content), Low Fuel Pressure or
any other condition that can
P2336 This Trouble Code Sets if Cylinder 1
(MAG) Knock Sensor reaches a Critical
Level. Can be caused by Excessive Knock
(Fuel Problems), a Lean Running
Condition or Engine Mechanical
Problems.
P1337 This Trouble Code Sets if the Engine
Controller Reaches the Maximum
Detonation Control Limit by Fuel
Correction on the PTO Cylinder. Can be
caused by Incorrect Fuel (low octane or
Ethanol content), Low Fuel Pressure or
any other condition that ca
P2337 This Trouble Code Sets if Cylinder 2
(PTO) Knock Sensor reaches a Critical
Level. Can be caused by Excessive Knock
(Fuel Problems), a Lean Running
Condition or Engine Mechanical
Problems.
P06B1 This Trouble Code sets if the Sensor
Supply 1 Voltage is below an acceptable
limit (approx. 4.50 Volts). Can be caused
by Damaged Wiring or Faulty/Shorted
Sensors.
CONDITION
205