3.
Disconnect the harness from the connector CN9 on the CN-2675G board.
CN10
Flexible flat cable
Harness
Flexible flat cable
4.
Unsolder the five coaxial connectors and the round type connector (8P) to detach the CN-2675G board.
5.
Install the removed parts by reversing the steps of removal.
4-6-4.
CN-2676 Board
Preparation
1.
Remove the rear panel assembly. (Refer to
2.
Remove the rear sub assembly (included in the HIF-62 board and the SDI-99 board) . (Refer to
Board")
Procedure
1.
Disconnect the harness (MIC) from the connector CN3 on the CN-2676 board.
HDCU2500
CN-2675G board
CN9
CN7
Remove solder
.
CN-2675G board
"4-4-1. Removal and Installation of Rear Panel
Assembly")
"4-6-1. HIF-62
4-23