Sony HDCU2500 Maintenance Manual page 135

3. Peel the UL tape and disconnect the optical cables from the connector (CN700) on the SDP-17 board.
Note
When disconnecting the optical cables, disconnect the cables holding the blue portion of the plug.
SDP-17 board
Mark
CN700
Optical cables
Notes
• When connecting the optical cables, push them into the connectors until a click sound is heard.
• Connect optical cable 1 to the connector CP201, and optical cable 2 to the connector CP401. If they are
connected to incorrect positions, the signal will not be output.
4. Remove the two screws (B3 x 5) , and remove the SDP-17 shield plate from the rear panel.
5. Remove the two spacers (A) and heat trans sheets (1) .
HDCU2500
Cover (SDP-17)
B3 x 5
UL tape
CN200
B3 x 5
B3 x 5
Fiber cable cover
Harness
4-17