Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 8 Internet Connection with PPPoA
LABEL
User Name
Password
IP Address
Connection
Network
Address
Translation
Back
Next
3.2.5 DHCP Setup
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual
clients to obtain TCP/IP configuration at start-up from a server. You can configure the ZyXEL
Device as a DHCP server or disable it. When configured as a server, the ZyXEL Device
provides the TCP/IP configuration for the clients. If you turn DHCP service off, you must
have another DHCP server on your LAN, or else the computer must be manually configured.
3.2.5.1 IP Pool Setup
The ZyXEL Device is pre-configured with a pool of IP addresses for the DHCP clients (DHCP
Pool). See the product specifications in the appendices. Do not assign static IP addresses from
the DHCP pool to your LAN computers.
3.2.6 Internet Access Wizard Setup: Third Screen
Verify the settings in the screen shown next. To change the LAN information on the ZyXEL
Device, click Change LAN Configurations. Otherwise click Save Settings to save the
configuration and skip to the section 3.13.
Chapter 3 Wizard Setup
DESCRIPTION
Enter the login name that your ISP gives you.
Enter the password associated with the user name above.
This option is available if you select Routing in the Mode field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not
fixed; the ISP assigns you a different one each time you connect to the Internet.
Click Obtain an IP Address Automatically if you have a dynamic IP address;
otherwise click Static IP Address and type your ISP assigned IP address in the IP
Address text box below.
Select Connect on Demand when you don't want the connection up all the time and
specify an idle time-out (in seconds) in the Max. Idle Timeout field. The default setting
selects Connection on Demand with 0 as the idle time-out, which means the Internet
session will not timeout.
Select Nailed-Up Connection when you want your connection up all the time. The
ZyXEL Device
will try to bring up the connection automatically if it is disconnected.
This option is available if you select Routing in the Mode field.
Select None, SUA Only or Full Feature from the drop-sown list box. Refer to
7 on page 71
for more details.
Click Back to go back to the first wizard screen.
Click Next to continue to the next wizard screen.
P-660R-Tx v2 Series User's Guide
Chapter
47
Advertisement
Table of Contents
Troubleshooting
