Firmware Screen; Table 30Diagnostic: Dsl Line - ZyXEL Communications P-660R-Tx v2 Series User Manual

P-660R-Tx v2 Series User's Guide
The following table describes the labels in this screen.
Table 30 Diagnostic: DSL Line
LABEL
Reset ADSL
Line
ATM Status
ATM Loopback
Test
Upstream Noise
Margin
Downstream
Noise Margin
Back

12.6 Firmware Screen

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a
.bin extension, for example, "ZyXEL.bin". The upload process uses HTTP (Hypertext
Transfer Protocol) and may take up to two minutes. After a successful upload, the system will
reboot.
Note: Only use firmware for your device's specific model. Refer to the label on the
bottom of your device.
Click Firmware to open the following screen. Follow the instructions in this screen to upload
firmware to your ZyXEL Device.
110
Click this button to reinitialize the ADSL line. The large text box above then displays
the progress and results of this operation, for example:
"Start to reset ADSL
Loading ADSL modem F/W...
Reset ADSL Line Successfully!"
Click this button to view ATM status.
Click this button to start the ATM loopback test. Make sure you have configured at
least one PVC with proper VPIs/VCIs before you begin this test. The ZyXEL Device
sends an OAM F5 packet to the DSLAM/ATM switch and then returns it (loops it
back) to the ZyXEL Device. The ATM loopback test is useful for troubleshooting
problems with the DSLAM and ATM network.
Click this button to display the upstream noise margin.
Click this button to display the downstream noise margin.
Click this button to go back to the main Diagnostic screen.
DESCRIPTION
Chapter 12 Maintenance