Security: 802.1X Static 64-Bit, 802.1X Static 128-Bit; Figure 35 Security: 802.1X Only For Wireless Client; Table 18 Security: 802.1X Only For Wireless Client - ZyXEL Communications 802.11b/g Wireless Access Point NWA-1100 User Manual

Figure 35 Security: 802.1x Only for Wireless Client

The following table describes the labels in this screen.

Table 18 Security: 802.1x Only for Wireless Client

LABEL
Security Mode
Data Encryption
IEEE802.1x
Authentication
EAP Type
User Information
Username
Password
Apply
Reset

7.4.3 Security: 802.1x Static 64-bit, 802.1x Static 128-bit

Use this screen to use 802.1x Static 64 or 802.1x Static 128 security mode for your ZyXEL
Device. Select 802.1x Static 64 or 802.1x Static 128 in the Security Mode field to display the
following screen.
ZyXEL NWA-1100 User's Guide
DESCRIPTION
Choose the same security mode used by the AP.
Select between None and Dynamic WEP. Refer to
information on using Dynamic WEP.
The options on the left refer to EAP methods. You can choose either TLS, LEAP,
PEAP or TTLS. The default value is PEAP.
The options on the right refer to authentication protocols. You can choose
between MSCHAPv2 and GTC.The default value is MSCHAPv2.
Supply the username of the account created in the RADIUS server.
Supply the password of the account created in the RADIUS server.
Click Apply to save your changes.
Click Reset to begin configuring this screen afresh.
Chapter 7 Wireless Security Screen
Section on page 161 for
81