Ip Routing Policy Setup; Table 249 Ip Routing Policy Setup - ZyXEL Communications ZyXEL ZyWALL 2WG User Manual

Chapter 46 IP Policy Routing
Table 248 Menu 25: Sample IP Routing Policy Summary (continued)
FIELD
Criteria/Action
Select Command
Select Rule
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.

Table 249 IP Routing Policy Setup

ABBREVIATION
Criterion
SP
DA
DP
P
T
PR
Action
T
P
Service
MD
MT
MR
MC

46.2 IP Routing Policy Setup

To setup a routing policy, perform the following procedures:
1 Type 25 in the main menu to open Menu 25 - IP Routing Policy Summary.
674
DESCRIPTION
This displays the details about to which packets the policy applies and how the
policy has the ZyWALL handle those packets. Refer to
detailed information.
Press [SPACE BAR] to choose from None, Edit, Delete, Go To Rule, Next Page
or Previous Page and then press [ENTER]. You must select a rule in the next
field when you choose the Edit, Delete or Go To commands.
Select None and then press [ENTER] to go to the "Press ENTER to Confirm..."
prompt.
Use Edit to create or edit a rule. Use Delete to remove a rule. To edit or delete a
rule, first make sure you are on the correct page. When a rule is deleted,
subsequent rules do not move up in the page list.
Use Go To Rule to view the page where your desired rule is listed.
Select Next Page or Previous Page to view the next or previous page of rules
(respectively).
Type the policy index number you wish to edit or delete and then press [ENTER].
MEANING
SA Source IP Address
Source Port
Destination IP Address
Destination Port
IP layer 4 protocol number (TCP=6, UDP=17...)
Type of service of incoming packet
Precedence of incoming packet
GW Gateway IP address
Outgoing Type of service
Outgoing Precedence
NM Normal
Minimum Delay
Maximum Throughput
Maximum Reliability
Minimum Cost
Table 249 on page 674 for
ZyWALL 2WG User's Guide