Chapter 9 DMZ Screens
Figure 121 NETWORK > DMZ
The following table describes the labels in this screen.
Table 46 NETWORK > DMZ
LABEL
DMZ TCP/IP
IP Address
IP Subnet Mask
RIP Direction
202
DESCRIPTION
Type the IP address of your ZyWALL's DMZ port in dotted decimal notation.
Note: Make sure the IP addresses of the LAN, WAN, WLAN and
DMZ are on separate subnets.
The subnet mask specifies the network number portion of an IP address. Your
ZyWALL will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the ZyWALL 255.255.255.0.
RIP (Routing Information Protocol, RFC1058 and RFC 1389) allows a router to
exchange routing information with other routers. The RIP Direction field controls
the sending and receiving of RIP packets. Select the RIP direction from Both/In
Only/Out Only/None. When set to Both or Out Only, the ZyWALL will
broadcast its routing table periodically. When set to Both or In Only, it will
incorporate the RIP information that it receives; when set to None, it will not send
any RIP packets and will ignore any RIP packets received. Both is the default.
ZyWALL 2WG User's Guide