F/W Upload Screen; Figure 317 Maintenance > Firmware Upload - ZyXEL Communications ZyXEL ZyWALL 2WG User Manual

Internet security appliance
Hide thumbs Also See for ZyXEL ZyWALL 2WG:
Table of Contents

Advertisement

Table 189 MAINTENANCE > Device Mode (Bridge Mode) (continued)
LABEL
DHCP
IP Pool Starting
Address
Pool Size
Bridge
IP Address
Apply
Reset

27.10 F/W Upload Screen

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a
.bin extension, for example, "zywall.bin". The upload process uses HTTP (Hypertext Transfer
Protocol) and may take up to two minutes. After a successful upload, the system will reboot.
See
Section 43.5 on page 655
Click MAINTENANCE > F/W UPLOAD. Follow the instructions in this screen to upload
firmware to your ZyWALL.
Only upload firmware for your specific model!
Figure 317 MAINTENANCE > Firmware Upload
ZyWALL 2WG User's Guide
DESCRIPTION
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows
individual clients (computers) to obtain TCP/IP configuration at startup from a
server. Unless you are instructed by your ISP, leave the DHCP check box
selected. Clear it to stop the ZyWALL from acting as a DHCP server. When
configured as a server, the ZyWALL provides TCP/IP configuration for the
clients. If not, DHCP service is disabled and you must have another DHCP
server on your LAN, or else the computers must be manually configured. When
set as a server, fill in the rest of the DHCP setup fields.
This field specifies the first of the contiguous addresses in the IP address pool.
This field specifies the size, or count of the IP address pool.
When the ZyWALL is in bridge mode, there is no need to select or clear this radio
button.
Click Bridge to go to the Bridge screen where you can view and/or change the
bridge settings.
Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the LAN
Interface IP Address field to access the ZyWALL again.
Click Reset to begin configuring this screen afresh.
for upgrading firmware using FTP/TFTP commands.
Chapter 27 Maintenance
521

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zywall 2wg - v4.03Zywall 2wg - v4.04

Table of Contents