Remote Management Limitations; Figure 84 Menu 24.11 Remote Management Control; Table 58 Menu 24.11 Remote Management Control - ZyXEL Communications ZyXEL ZyAIR G-1000 User Manual

G-1000 User's Guide
Enter 11, from menu 24, to display Menu 24.11 - Remote Management Control (shown
next)

Figure 84 Menu 24.11 Remote Management Control

TELNET Server:
FTP Server:
Web Server:
SNMP Service:
DNS Service:
The following table describes the fields in this menu.

Table 58 Menu 24.11 Remote Management Control

FIELD
TELNET Server:
FTP Server:
Web Server:
SNMP Service:
DNS Service:
Port
Access
Secured Client IP
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.

19.3.5 Remote Management Limitations

Remote management over LAN or WAN will not work when:
134
Note: If you enable remote management of a service, but have
applied a filter to block the service, then you will not be able to
remotely manage the service.
Menu 24.11 - Remote Management Control
Port = 23
Secure Client IP = 0.0.0.0
Port = 21
Secure Client IP = 0.0.0.0
Port = 80
Secure Client IP = 0.0.0.0
Port = 161
Secure Client IP = 0.0.0.0
Port = 53
Secure Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Each of these read-only labels denotes a server or service that you may use to
remotely manage the G-1000.
This field shows the port number for the remote management service. You may
change the port number for a service if needed, but you must use the same
port number to use that service for remote management.
Select the access interface (if any) by pressing the [SPACE BAR]. Choices are:
LAN only, WAN only, All or Disable. The default is LAN only.
The default 0.0.0.0 allows any client to use this service to remotely manage the
G-1000. Enter an IP address to restrict access to a client with a matching IP
address.
Chapter 19 System Maintenance and Information
Access = ALL
Access = ALL
Access = ALL
Access = ALL
Access = ALL