Authentication Required: Wpa2-Psk; Figure 24 Wireless Lan: 802.1X/Wpa For Wpa2 Protocol; Table 20 Wireless Lan: 802.1X/Wpa2 For Wpa Protocol - ZyXEL Communications ZyXEL ZyAIR G-1000 User Manual

Figure 24 Wireless LAN: 802.1x/WPA for WPA2 Protocol

The following table describes the labels not previously discussed

Table 20 Wireless LAN: 802.1x/WPA2 for WPA Protocol

LABEL
Key Management
Protocol
WPA Compatible
WPA Group Key
Update Timer
Authentication
Databases
Apply
Reset
Please see Table 17

6.7.5 Authentication Required: WPA2-PSK

Select Authentication Required in the Wireless Port Control field and WPA2-PSK in
the Key Management Protocol field to display the next screen.
Chapter 6 Wireless LAN
DESCRIPTIONS
Choose WPA2 in this field.
Check this box if you want your G-1000 to support WPA2 and WPA at the same
time. This might reduce the performance of the device, however.
The WPA Group Key Update Timer is the rate at which the AP (if using WPA2-
PSK key management) or RADIUS server (if using WPA2 key management)
sends a new group key out to all clients. The re-keying process is the WPA2
equivalent of automatically changing the WEP key for an AP and all stations in a
WLAN on a periodic basis. Setting of the WPA Group Key Update Timer is also
supported in WPA2-PSK mode. The G-1000 default is 1800 seconds (30 minutes).
This field is disabled.
Click Apply to save your changes back to the G-1000.
Click Reset to begin configuring this screen afresh.
for information on the additional fields shown in this screen.
G-1000 User's Guide
67