Configuring Advanced Lan Setup; Figure 43 Advanced Lan Setup; Table 24 Advanced Lan Setup - ZyXEL Communications P-2802H(W)(L)-I Series User Manual

Table 23 LAN IP (continued)
LABEL
Cancel
Advanced Setup

7.4.1 Configuring Advanced LAN Setup

Use this screen to edit your ZyXEL Device's RIP, multicast, any IP and Windows Networking
settings. Click the Advanced Setup button in the LAN IP screen. The screen appears as
shown.

Figure 43 Advanced LAN Setup

The following table describes the labels in this screen.

Table 24 Advanced LAN Setup

LABEL
RIP & Multicast
Setup
RIP Direction
RIP Version
Multicast
Any IP Setup
P-2802H(W)(L)-I Series User's Guide
DESCRIPTION
Click Cancel to begin configuring this screen afresh.
Click this button to display the Advanced Setup screen and edit more details of
your LAN setup.
DESCRIPTION
Select the RIP direction from None, Both, In Only and Out Only.
Select the RIP version from RIP-1, RIP-2B and RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a multicast group. The ZyXEL Device supports both IGMP
version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.
Select the Active check box to enable the Any IP feature. This allows a computer
to access the Internet without changing the network settings (such as IP address
and subnet mask) of the computer, even when the IP addresses of the computer
and the ZyXEL Device are not in the same subnet.
Note: You must enable NAT/SUA to use the Any IP feature on the
ZyXEL Device.
When you disable the Any IP feature, only computers with dynamic IP addresses or
static IP addresses in the same subnet as the ZyXEL Device's LAN IP address can
connect to the ZyXEL Device or access the Internet through the ZyXEL Device.
Chapter 7 LAN Setup
95