Figure 13 Internet Access Wizard Setup: Isp Parameters; Table 6 Internet Access Wizard Setup: Isp Parameters - ZyXEL Communications P-2802H(W)(L)-I Series User Manual

Figure 13 Internet Access Wizard Setup: ISP Parameters

The following table describes the fields in this screen.

Table 6 Internet Access Wizard Setup: ISP Parameters

LABEL
Mode
Encapsulation
Back
Next
Exit
4 The next wizard screen varies depending on what mode and encapsulation type you use.
All screens shown are with routing mode. Configure the fields and click Next to
continue. See
When you use the connection wizard to configure the Internet access using
PPPoE, the ZyXEL Device is set to get an IP address from the ISP
automatically. To set up a static WAN IP address with PPPoE, use the
Network > WAN screen.
P-2802H(W)(L)-I Series User's Guide
DESCRIPTION
Select Routing (default) from the drop-down list box if your ISP give you one IP
address only and you want multiple computers to share an Internet account. Select
Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If
you select Bridge, you cannot use Firewall, QoS, DHCP server and NAT on the
ZyXEL Device.
Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. This field is available only when you select Routing in the Mode field.
Choices are Ethernet and PPPoE.
Click Back to go back to the previous screen.
Click Next to continue to the next wizard screen. The next wizard screen you see
depends on what protocol you chose above.
Click Exit to close the wizard screen without saving your changes.
Section 3.3 on page 58
Chapter 3 Internet and Wireless Setup Wizard
for wireless connection wizard setup
55