Specifications - Siemens SIRIUS 3RW5 Equipment Manual

A.2.2

Specifications

The following specifications apply in the data tables:
● The addresses are represented as hexadecimal values (hex) and, under that, in square
brackets "[...]" or in a separate column as decimal values (dec).
● The access to undefined addresses is illegal and generates an error message.
● Non-relevant (reserved) entries are not listed in the data tables.
On read access to data tables, logical zeros are returned for reserved address ranges.
On write access to the data tables, write commands for reserved address ranges are
ignored.
Refer to the information on address ranges in chapter Memory image (Page 138).
● In data tables for parameters, codes are shown in square brackets "[...]". "[D
the default encoding.
Object number (Obj. No.)
The object number (Obj. No.) is used for unique identification of all parameters available in
the 3RW5 soft starter. In the case of a parameterization error, the object number of the faulty
parameter is displayed in data table "Soft starter diagnostics" (Page 152) or in the data table
"HMI diagnostics" (Page 179) under "Faulty parameter number".
SIRIUS 3RW5 Modbus communication module
Equipment Manual, 03/2020, A5E43676481002A/RS-AC/003
Appendix
A.2 Data tables
]" describes
x)
137