8.
Install, as applicable to the S‐Series chassis, the nylon washers and spacers provided in the
upgrade kit on the studs extending from the backplane.
–
S3 chassis: A nylon washer (.100") and a nylon spacer (.375") go on each backplane stud.
See Figure
2‐9.
Figure 2-9
Installing the Nylon Washers and Spacers on the S3 Chassis Backplane Studs
1
Backplane stud
2
Nylon washer (.100")
Note: The .100" washers, which are included only with the S3-POE-4BAY-UGK upgrade kit, apply
to the S3 upgrade only.
Installing the PoE Subsystem and the Bus Bar
3
Nylon spacer (.375")
Enterasys S-Series PoE Subsystem Upgrade Installation Guide 2-11