Installing the PoE Subsystem and the Bus Bar
6.
If not already done, feed the PoE subsystem's ribbon cable down into the S‐Series chassis
through the opening between the PoE subsystem and the S‐Series chassis.
7.
Attach the PoE subsystem's ribbon cable to the connector on the S‐Series chassis backplane.
See Figure
Figure 2-8
Backplane
1
PoE subsystem ribbon cable
2-10 Installing the PoE Upgrade Kit
2‐8.
Attaching the PoE Subsystem Ribbon Cable to the S-Series Chassis
Note: Ensure that the ribbon cable is connected properly to the backplane connector as
misalignment can occur.
2
S-Series chassis backplane connector