Valve Replacement
1) Remove the faceplate - see instructions in
manual.
2) Remove the safety screen and glass door.
a) Pull the spring hook on the left that holds
the door in place. Place the hook into
the opening towards the outside of the
bracket. Repeat on right side
Spring Hook
Outside Bracket
opening
b) Swing the door out 45 degrees and lift up
and out.
.
3) Remove the logs.
4) Remove brick panels, if installed.
5) Remove the valve shield by undoing the 2
screws.
Valve Shield
maintenance
6) Disconnect the gas connection to the valve.
7) Disconnect the ignitor wire from the DC
Sparker.
8) Disconnect the valve wires from the DC
Sparker.
DC Sparker Wires
9) Unplug the 2 connectors from the valve.
Liberty
L234-11 Direct Vent Gas Insert
®
|
39