Lighting / Shutdown Procedure - Regency Liberty L234 Series Owners & Installation Manual

owner's information
Lighting Procedure
IMPORTANT: The remote control system supplied with this appliance has
several options for starting/operating the appliance using the battery holder
and ON/OFF key on the handheld transmitter.
Prior to operating this appliance, please read the remote control operating
instructions (packaged with remote control) to understand how to operate
this remote control system.
Important: If the pilot does not hold, turn pilot knob to "OFF" position. Wait 5
minutes to clear gas. If you smell gas - STOP! Follow the safety information
above. If you don't smell gas, repeat steps 1-6.
1. Push in gas control knob slightly and turn to "PILOT" position.
2. Push in control knob all the way and hold in until the pilot lights up. Con-
tinue to hold the control knob in until a faint buzzer sound can be heard
for 4 seconds informing the operator that the knob can now be released.
Release knob.
3. Push in gas control knob slightly and turn to "ON" position.
4. Ensure the receiver is in the remote position.
5. Press and release the ON/OFF button on the remote handheld transmitter.
An audible beep should be heard from the receiver. (See diagram 1) Ensure
the receiver is in the remote position.
ON/OFF
Button
Remote shown in Manual Mode on Hi
6. The unit will turn on.
|
8
Liberty L234-11 Direct Vent Gas Insert
®
Diagram 1
*
Shutdown Procedure
1. Press "OFF" on the remote or slide receiver switch from remote to "OFF".
2. Turn the gas control knob to the "OFF" position to turn off the pilot. Pilot
may be shut off during prolonged non-use periods to conserve fuel.
3. If service is to be performed - you must disconnect power and shut off gas
to the unit.
*
*
*
* Not offered on all models.
See remote control instructions for details.