Continuing A Seam After An Error; Continuing A Seam In Repair Mode After An Error - DURKOPP ADLER 991-210-10 Series Service Instructions Manual

16.8 Continuing a seam after an error

16.8.1 Continuing a seam in Repair mode after an error

In Repair mode you can move to any desired point on the contour, e.g. in
order to continue the seam program from this position after an error has
occurred.
To continue a seam in Repair mode after an error:
1. Press the button Reparaturmodus (Repair mode)
 The
Fig. 73: Continuing a seam in Repair mode after an error
2. Use the Vor (Forwards) and Zurück (Back) buttons to move to the
OR
3. Use the buttons Vor ++ (Forwards) and Zurück ++ (Back) to skip to
4. Press the Weiternähen (Continue sewing) button.
 The program jumps back to the start screen and sewing of the seam
86
the start screen.
Reparaturmodus (Repair mode)
displayed.
point where sewing is to continue.
the beginning of the next or the beginning of the previous seam section.
continues from the selected point.
window is
Service Instructions 911-210-10 - 00.0 - 06/2020
Programming
on