Adjusting The Sewing Foot Stroke Relative To The Needle Bar Stroke - DURKOPP ADLER 991-210-10 Series Service Instructions Manual

9.4 Adjusting the sewing foot stroke relative to the needle
Fig. 31: Adjusting the sewing foot stroke relative to the needle bar stroke
(1) - Lever
(2) - Lifting gear
(3) - Eccentric
Proper setting
The lifting gear (2) must be switched on so that it performs a stroke.
The stop block (6) must then lie against the right-hand stop screw (5).
The eccentric (3) for the sewing foot stroke must be set so that
To set the sewing foot stroke relative to the needle bar stroke:
1. Switch off and on the machine again.
2. Reference the machine.
3. Press Extras > Service > Multitest (Multi test) > Hublage
4. Press Hüpfer/Drücker (Jumping foot/presser foot) until
5. Switch on the sewing foot stroke in the control.
44
bar stroke
①
② ③
• the needle bar is at bottom dead center - the presser foot is lowered
• after the looping stroke - the presser foot stroke starts.
einstellen (Set stroke position).
the jumping foot is selected.
(4) - Sewing foot stroke
(5) - Stop screw
(6) - Stop block
Service Instructions 911-210-10 - 00.0 - 06/2020
Sewing foot lift
⑥
⑤
④