Changing The Presser Bar; Disassembling The Presser Bar - DURKOPP ADLER 991-210-10 Series Service Instructions Manual

Changing the presser bar

12 Changing the presser bar

12.1 Disassembling the presser bar

Fig. 45: Disassembling the presser bar (1)
(1) - Bearing with gear wheel
(2) - Threaded pins
(3) - Drive
To disassemble the presser bar:
1. Remove the motor cover.
2. Loosen the threaded pins (2) and pull the bearing with the gear
3. Disassemble the drive (3).
4. Loosen the screws (4) and remove the drive shaft.
5. Loosen the screw (5).
Service Instructions 911-210-10 - 00.0 - 06/2020
①
②
③
④
wheel (1) out towards the front.
⑤
(4) - Screws
(5) - Screw
59