Assembly And Disassembly - Genie Super-Straddle Operator's Manual

Second Edition • First Printing

Assembly and Disassembly

To move the Super-Straddle through a doorway or
to set it up after shipping, follow these instructions.
Assemble or disassemble the Super-Straddle
only on a firm, level surface.
Two people are required to safely maneuver and
support the Super-Straddle components through
this procedure.
Do not allow Super-Straddle components to
drop.
telescoping tube
bolt and washer
wing nut and
washer
Part No. 133409
end frame
wear pad
Super-Straddle
Assembly and Disassembly
Assembly
1 Apply the caster brakes. Set the caster swivel
locks parallel to the straddle platform tubes.
2 Both winch cables must be fully lowered.
3 Be sure that the telescoping tubes are inserted
and pinned to the same length in the straddle
platform.
4 Move the end frame
marked Base Frame
(refer to decal on base
frame) to the end of
the straddle platform
nearest the cross
member.
5 One person must support the end frame while
the other attaches it to the straddle platform.
The winch handle should point away from the
machine.
6 Position the wear pads and attach each one with
the supplied bolts, washers and wing nuts.
7 Move the end frame
marked Telescoping
Base Frame (refer to
decal on telescoping
base frame) to the
other end of the
straddle platform and
repeat steps 5 and 6.
8 Make sure all wing nuts are tight.
9 Connect the electrical cords.
Operator's Manual
133405 A
133406 A
7