Figure 3: Rtm Default Jumper Settings - Juniper CTP2000 Series Upgrade

Upgrading the CTP2000 Series Device to CTPOS 7.x
12

Figure 3: RTM Default Jumper Settings

Board Compatibility
(set to suit
processor board)
PP310
PP332
Confirm that Ethernet dip switches SW1 and SW2 are set to ON, and that SW3 and
5.
SW 4 are set to OFF (see
Install the 4-GB CompactFlash card from the upgrade kit in the new RTM and install
6.
the new RTM in the chassis. See
CompactFlash Card" on page
Attach a terminal server or similar device to the serial console port, COM2, on the RTM.
7.
This device will be used to interact with the script that runs when the upgrade
CompactFlash card is booted.
Remove the CPU card from the chassis, and replace the memory module on the CPU
8.
card with that from the upgrade kit. Install the memory module shipped with the kit
only after you have finished these tasks. See
Memory Modules in the PP310 or PP332 CPU" on page 23
Series Components for Memory Upgrades.
Reset the BIOS to factory defaults. See
9.
and Later Upgrade (PP310)" on page
Reconnect all Ethernet cables.
10.
Replace the power cord.
11.
Power on the system and follow the procedure
12.
Card" on page 14 to respond to the instructions that appear on the serial console. You
have the option of conserving information from a prior release of the operating system
or setting the device for firstboot with CTP0S 7.0R1 and later.
Figure 3 on page 12).
"Installing or Removing a CTP2000 Series
26.
"Installing or Replacing CTP2000 DRAM
"Restoring BIOS Defaults for the CTPOS 7.0R1
24.
"Using the Upgrade CompactFlash
and Upgrading CTP2000
Copyright © 2015, Juniper Networks, Inc.