Juniper CTP2000 Series Upgrade page 15

Copyright © 2015, Juniper Networks, Inc.
The CompactFlash script runs an application that checks for the proper BIOS and
upgrades the BIOS if necessary. The application checks for proper FPGAs on the cards
and daughter cards installed and upgrades them as necessary.
When used to prepare a system for firstboot into CTPOS 7.0R1 or later, all cards and
daughter cards intended to be run on the system should be installed before booting the
flash for the first time.
If the system is migrating from an old CompactFlash card running CTPOS 4.6R7 or 5.4R3
through 5.4R6, the application transfers all necessary information from the old
CompactFlash card to the new CompactFlash card and leaves the system in a state with
all configured and activated circuits running.
Use one of the following procedures after completing either
Upgrade Kit" on page 11 or
Migrating from a Previous Operating System on page 16
Preparing a System for Firstboot Using CTPOS 7.0R1 and Later on page 20
Chapter 2: Upgrading the CTP2000 Series Device to CTPOS 7.x
"Upgrading with the PP332 Upgrade Kit" on page
"Upgrading with the PP310
13.
15