Juniper CTP2000 Series Upgrade page 18

Upgrading the CTP2000 Series Device to CTPOS 7.x
18
Please remove the old flash, hit return when finished.
Migrating system ID to new flash.
* The system will reboot when finished.
INIT: Sending processes the TERM signal
Gathering system information.
* Please wait this could take up to 45 seconds.
Found:
System type PP310
Bios 2.21
Memory installed 1024 MB
Slot 0: Type T1E1
FPGA 0xea * needs 0xea
Slot 1: Type Serial
FPGA 0x73
Slot 2: Type FXS
FPGA 0x5010150
ID restored Yes
Hit return to continue...
Restarting syslog.
. done.
Upgrading T1E1 card in slot 0 to FPGA rev 0xea.
Upgrading FPGA on card 0. Please wait for completion.
. done.
Upgrading FPGA on card 0 complete.
Upgrading Winmon. Please wait for completion.
..... . done.
Upgrading Winmon complete.
Upgrading Daughter cards. Please wait for completion.
. done.
Upgrading Daughter cards complete.
**** ****
Finished preparing system for running CTPOS 6.0R1.
Finished migrating ID from CTPOS . Reboot required.
**** ****
**** ****
Please verify that all circuits and system setting are
correct after the system reboots.
**** ****
Hit return to reboot the system.
Copyright © 2015, Juniper Networks, Inc.