Error Messages; Sequencer Errors; Custom Accompaniment Programmer Errors; Disk Errors - Yamaha PortaTone PSR-6000 Owner's Manual

Error Messages

If you attempt to perform an illegal operation or some other problem occurs, the PSR-6000 will usually warn you
with an error message that provides an idea of what caused the problem and how it can be rectified. The following
are the error messages you're most likely to see during normal operation.
Some of the error displays automatically revert to the previous display after a few seconds, while others require
that the CANCEL LCD button be pressed to exit from the error display.
If a damaged disk is used the data countdown during FROM DISK or TO DISK operations may stop and the load
or save operation may get "hung up." In this case, eject the disk from the drive even though the DISK IN USE lamp
may be on. Discard the damaged disk.

Sequencer Errors

........................................................................................................................................................................
Time signature conflict!
Playback not possible.
Data error!
Playback stopped.
Memory full!
Recording stopped.
Too much data!
Operation cancelled.

Custom Accompaniment Programmer Errors

Memory full!
Cannot store data.
Work area full!
Recording stopped.
Preset track!
Cannot record.
Edited data not stored!

Disk Errors

..........................................................................................................................................................................................
Disk error!
Cannot continue.
Disk full!
Cannot continue.
Bad file name.
You have attempted to play back a sequence using a different time
signature from the one with which it was recorded.
A data error has been encountered during playback which makes
continued playback impossible.
The sequencer memory is full and no more data can be recorded. You
may have to clear songs or data to make room. Save data you want to
keep to floppy disk, then clear it from the PSR-6000 memory.
There is too much data for the specified edit operation. Simplify the
sequence and try again.
.............................................................................................
Not enough memory is available to store all the data. Simplify the
accompaniment to reduce the amount of data, then try storing the data
again.
The work area memory used during custom accompaniment recording
is full and recording cannot continue. Simplify the accompaniment so
that it fits in the available work area.
This message will appear if you attempt to set a track which contains
preset data to the record mode.
You have attempted to exit from the Custom Accompaneiment Pro-
grammer or change styles without first saving the edited data. Press the
appropriate LCD button to continue.
A data error has occurred during a save, load, delete, or format
operation. Press the CANCEL LCD button to clear this error message.
The floppy disk does not have enough remaining capacity to carry out
the specified operation. Press the CANCEL LCD button to clear this
error message.
The file name is all spaces and cannot be recognized by the PSR-6000.
111