Error Messages - Yamaha DISKLAVIER MX1Z Service Manual

ERROR MESSAGES

While operating your Disklavier an error message may appear in the display. If an error message does appear, look in the
table below for an explanation of the message.
Note: This table does not explain every error message.
PianoSoft songs cannot be re-recorded, as they are write-protected.
The current function cannot be executed because protected files exist
on the floppy disk.
No more song data can be recorded onto the floppy disk because the
disk is full.
Use another floppy disk.
The current function cannot be performed because the floppy disk's
erasure protection tab is set to "protected".
Set the disk's erasure protection tab to "unprotected".
No more song data can be recorded onto the disk because the disk is
nearly full.
No more than 66 songs can be recorded onto an E-SEQ type disk.
No more than 99 songs can be recorded onto an SMF type disk.
The current function cannot be performed because this disk contains
no songs or only one song.
A wrong floppy disk has been inserted as the destination disk.
Insert the correct floppy disk.
The floppy disk is either new and has not yet been formatted for use
with the Disklavier or it uses a format not recognized by the Disklavier.
Format the floppy disk.
The destination disk must be the same format as the floppy disk to be
copied.
You must select the track you want to record before starting recording.
Only E-SEQ files can be recorded onto an E-SEQ type disk.
The floppy disk may be damaged.
Press the Stop key to clear the message.
MX1Z
33