Volume Control - Yamaha PortaTone PSR-6000 Owner's Manual

Playing DOC (Disk Orchestra Collection) & General MIDI Music Software Disks
B
Eject the Disk When Done
When you've finished with the currently loaded
disk, simply press the disk drive EJECT button to
remove it. This will automatically exit the DISK
ORCHESTRA mode.
NOTES
• There are actually three ways to exit from the DOC
mode:
1) Remove the DOC disk.
2) Press the [DISK ORCHESTRA/GENERAL MIDI] or
[EXIT] button (the normal, DOC, and General MIDI
modes are selected in sequence).
3) Receive any MIDI exclusive message that selects a
different mode from an external MIDI device.
• NEVER eject a disk or turn the power off while:
1) the DISK ORCHESTRA function is playing.
2) the DISK is formatting or recording.

Volume Control

If the volume control/mute display is not show-
ing, press the VOLUME/MUTE LCD button to
recall it. The volume-control LCD dials function in
the same way as the volume controls in the normal
play mode, each controlling the volume of the cor-
responding part, as listed below. As always, the
MASTER VOLUME control adjusts the overall
volume level.
ORC1 Adjusts the volume of ORCH.1 played on
the keyboard.
SONG Adjusts the overall volume of the song.
RIGHT Adjusts the volume of the right-hand part.
LEFT Adjusts the volume of the left-hand part.
ACC Adjusts the volume of the disk backing.
BASS Adjusts the volume of the disk bass part.
RHY Adjusts the volume of the disk rhythm part.
NOTES
• Operation of the volume controls may be different with
some songs. Further, the reverb or other effect can be
turned on or off for all parts by using the REVERB or
EFFECT button.
• During DOC playback reverb (type) ON/OFF data may
be read from the disk. When OFF data is received, the
.................................................................................................................................................
..............................................................................................................................................................................
depth values for all parts other than the part you are playing
are set to "0." This means that unless you change the depth
setting, reverb cannot be applied to those parts even if the
REVERB indicator is lit. Also, since the effect depth values
for all parts other than the part you will be playing are set to
"0" before DOC playback is started, you will have to change
the depth settings before effects can be applied to those
parts, even if the EFFECT indicator is lit.
• Since only the ORCH.1 voice is used for the part played on
the keyboard in the DOC mode, no ORCH.2 volume control is provided.
45