Erase; Note Shift - Yamaha PortaTone PSR-6000 Owner's Manual

The Sequencer
least as "short" as the shortest notes in the track to be quantized. If you quantize a track containing 16th notes to 1/8 (8th notes),
for example, some of the 16th notes will be aligned with 8th note beats, thus ruining the track.

ERASE

Erases all note and event (pitch bend, volume
changes, etc.) data from the specified measure or
range of measures in the specified track (accompa-
niment track not available), leaving blank measures.
Use the TRACK LCD dials to set the track
number, the TOP LCD dial to set the number of the
first measure in the range to be erased, and the LAST
LCD dial to set the number of the last measure in the
range to be erased.
Once the track and measure numbers have been
selected, press the EXECUTE LCD button to actu-
ally execute the erase operation. "Executing."
will appear on the display while the operation is in
progress, and "Completed." will appear briefly
when the operation has finished.
Immediately after execution an "UNDO" LCD
button will appear on the left side of the display, and
that button can be used to undo the erase operation
if it was executed by mistake. The undo function is
only available until the next operation is performed.
NOTES
• An erase operation leaves the specified measures intact but blank.

NOTE SHIFT

Shifts the pitch of notes in the specified measures
of the specified track (accompaniment track not
available) up or down by a maximum of two octaves,
in semitone increments.
Use the TRACK LCD dials to set the track
number, the SHIFT LCD dials to set the amount of
note shift (see "NOTES" below), the TOP LCD dial
to set the number of the first measure in the range in
which the notes are to be shifted, and the LAST LCD
dial to set the number of the last measure in the range
60
Erase measures 4 through 6.
1 2 3 4
TRACK 1
TRACK 1 1 2 3 4
Measures 4 — 6 "blank, "
containing only rests.
5 6 7 8 9
5 6 7 8 9