Playing The Psr-6000; Selecting & Playing Voices - Yamaha PortaTone PSR-6000 Owner's Manual

Playing the PSR-6000

Before You Begin
Before playing your PSR-6000 for the first time,
it might be a good idea to re-initialize it to the
original factory settings just in case these have been
changed at some point before you receive the instru-
ment. To do this, turn the [POWER] switch ON
while holding the [EXIT] and [DEMO] buttons.
When the display shown to the right appears, use
the LCD dials to select the language you want the
HELP text and messages to be displayed in, then
press the OK LCD button.
CAUTION
• When the above initialization procedure is carried
out, all sequencer and custom accompaniment
data will also be initialized and therefore lost!
Z
Turn Power On and Set Initial Volume Levels
Press the [POWER] button to turn the power
ON, and set the [MASTER VOLUME] control
about half way toward its highest setting. Also make
sure that the RHY, BASS, CHD2, CHD1, ORC2,
and ORC1 volume levels on the LCD are set to their
maximum "100" levels (use the corresponding LCD
dials to set these volume levels if necessary). You
can set the [MASTER VOLUME] control for the
most comfortable overall volume level after begin-
ning to play.
NOTES
• No sound will be produced if all volume levels other
than the [MASTER VOLUME] control are set to their
minimum values.
X
Select the Orchestration
The PSR-6000 has three orchestration modes,
selected by the corresponding ORCHESTRATION
buttons. The corresponding ORCHESTRATION LED
will light.
12
Selecting & Playing Voices
MASTER
VOLUME
MAX
MIN
.....................................................................................................................................................
ORCH.
EXIT
DEMO
POWER
...............................................................................................
ORCHESTRATION
ORCH. ORCH. LEFT HARMONY
1 2+1 2 1 HOLD
SUSTAIN REVERB EFFECT