Error Messages - Yamaha P-200 Service Manual

P-200

ERROR MESSAGES

Occasionally you may encounter certain error messages which appear in the LCD screen. Below is a list with descriptions of each.
The internal backup battery charge is low and the battery should be replaced.
Too much MIDI data is being received at once. Reception of data is interrupted and cannot be
continued. Reduce the amount of data and attempt the operation again.
An error occurred during reception of MIDI data. Check all MIDI connections, settings, etc., and
attempt the operation again.
An error occurred during reception of bulk data. Check all MIDI connections, settings, etc., and
attempt the operation again.
Certain data cannot be transmitted or received because a MIDI Filter is set to On. Check each
MIDI Filter setting in Edit mode.
Bulk data cannot be transmitted or received because the Device Number parameter is either
turned off or does not match that of the connected device.
The Send Bulk Data operation cannot be executed when MIDI Merge is on.
26