Mix Send View Screen - Yamaha PM5D Owner's Manual

PAN/ROUTING function

MIX SEND VIEW screen

This screen lists the signals sent from the input channels to
the MIX buses. You can also edit the settings from within
this screen.
MIX SEND VIEW
1
A CH to MIX/MIX from CH
Select one of the following two types of screen display.
❏ When the CH to MIX button is on
The screen shows the status of the signals sent from a
specific input channel (input channel / ST IN channel)
to all MIX buses. (Use the scroll bar to see input chan-
nels that are not currently shown.)
❏ When the MIX from CH button is on
The screen shows the status of the signals sent from all
input channels to a specific MIX bus.
280
PM5D/PM5D-RH Owner's Manual
2
3
Reference section
B SEND LEVEL, PRE/POST (Send level / Send
point)
Select one of the following two parameters to view in
the grid.
❏ When the SEND LEVEL button is on
The send levels of the signals sent from input channels
to MIX buses are shown in the grid as bar graphs.
Except for the fact that the send-sources are input
channels and the send-destinations are MIX buses, the
bar graph display is the same as in the MIX to
MATRIX VIEW screen (MATRIX/ST function)
(➥ p.240).
To edit the send level of a signal, move the cursor to
the grid where the desired channel and MIX bus inter-
sect, and turn the [DATA] encoder. To switch a MIX
send on/off, click the grid where the desired channel
and MIX bus intersect.
If the SEND LEVEL button is on, you can select a
desired grid and copy its send level (pan) value to other
channels (horizontal direction) or to other MIX buses
(vertical direction), or switch all grids on/off
simultaneously.
To do so, move the cursor to the desired grid; then
hold down the [SHIFT] key and press the [ENTER]
key. (Alternatively, hold down the [SHIFT] key and
click the desired grid.) When the following window
appears, select one of the following choices to copy,
and click the OK button.
LEVEL COPY [ALL MIX
Copy the send level (pan) value of the selected grid to
all MIX buses.
LEVEL COPY [ALL CH
Copy the send level (pan) value of the selected grid to
all input channels.
LEVEL COPY [ALL CH x ALL MIX]
Copy the send level (pan) value of the selected grid to
all input channels / all MIX buses.
ALL OFF [ALL MIX ]
Turn off the signals sent from the specified input
channel to all MIX buses.
ALL ON [ALL MIX ]
Turn on the signals sent from the specified input
channel to all MIX buses.
ALL OFF [ALL CH ]
Turn off the signals sent from all input channels to
the specified MIX bus.
]
]