Calibrating The Faders; Adjusting The Analog Input Gain (Pm5D-Rh Model Only); Adjusting The Output Gain - Yamaha PM5D Owner's Manual

19
Other functions

Calibrating the faders

Here you can execute a semi-automatic procedure for cali-
brating the faders of the specified channel strip (INPUT,
DCA, STEREO A/B, ST IN/FX RTN). This window will
also appear if a problem with the fader settings is detected
when the PM5D is started up.
1 Click a fader select button to add a check mark
to the faders you want to calibrate.
If problems with certain faders were detected during
start-up, those buttons will be on (green), and check
marks will already be shown for them.
2 Click the START CALIBRATION button; calibra-
tion will begin automatically.
A progress bar will indicate the state of the process.
3 The automatic processing will end when the
progress bar reaches 60%. Manually move all
faders you specified for calibration to the posi-
tions listed below in the following order:
1 –∞
2 –20 dB
3 0 dB
4 +10 dB
4 After you have set the faders to the correct
position, press the [ENTER] key.
Processing will proceed to the next fader position.
5 Repeat steps 3–4 for each fader position
6 Verify that calibration has been completed and
that all fader select buttons are now off. Then
click the OK button.
The calibration settings will be stored in internal mem-
ory. If a fader select button remains on (green),
calibration has failed. Try executing calibration once
again.
Note
The progress bar will indicate "Writing..." while the settings are
being written to internal memory; do not turn off the power
while this indication is visible.
148
PM5D/PM5D-RH Owner's Manual
Adjusting the analog input gain
(PM5D-RH model only)
If necessary, you can make fine adjustments in steps of 0.1
dB to the gain of the specified analog input port. Since the
input levels of all ports are set to match each other when
the PM5D is shipped from the factory, you will normally
not need to change these settings.
Note
Since these are set to optimal values at the factory, the default
values will differ between input ports. Initializing the internal
memory will return these settings to their factory-set values.
To adjust the gain, click the
left and right of each box to specify the gain of each input
port in 0.1 dB units. If you want to restore all input ports
to their factory settings, click the FACTORY PRESET but-
ton. Click the OK button to apply the settings.

Adjusting the output gain

If necessary, you can make fine adjustments in steps of 0.01
dB to the gain of the specified output port. The factory set-
1 – 4 .
ting is 0.00 dB.
To adjust the gain, click the
left and right of each box to specify the gain of each output
port in 0.01 dB units. If you want to reset all output ports
to 0.00 dB, click the FACTORY PRESET button. Click the
OK button to apply the settings.
Operating section
/ buttons located at the
/ buttons located at the