Mix Outputs; Selecting Aux/Sub Group, Pre/Post Fade, Send Point Etc - Yamaha M7CL-48 Quick Start Manual

Mix outputs; selecting aux/sub group, pre/post fade, send point etc.

There are 16 mix bus outputs available in addition to the matrix, master and monitor outputs. The mix buses can
be confi gured as variable auxes or fi xed sub-groups. In M7CL-32/48 all outputs share the 16 XLR Omni outs, AES/EBU
out and MY card slot outs. In M7CL-48ES the outputs share the 8 XLR Omni outs, the AES/EBU out, the MY card slot
outs and the 24 EtherSound outputs which will appear on the SB168-ES ID#1,2,3 if they are connected.
By default, the 16 mix buses are all variable (auxiliaries). The fi rst 12 are pre fade sends (monitor) and the last
4 are post fade (effects), but these can all be changed individually.
Change individual sends.
To change a mix group from variable (aux) to fi xed (sub-group), or to change the variable send point from prefader
to pre-EQ/dynamics, access the BUS SETUP pop-up from the SETUP page. Confi gure mixes as stereo here too.
To change mixes pre/
post, press on a knob
image to get the MIX
SEND popup
17
M7CL Quick Start Guide Part 1
Press for output routing,
insert, EQ or Dynamics
popups.
Use encoders below to
adjust sends from mix
groups into matrix.
Route to Stereo and pan
from here.
Change whole mixes.