Security Screen - Yamaha PM5D Owner's Manual

UTILITY function

SECURITY screen

In this screen you can prohibit console operation (Console
Lock) or prohibit editing for specific parameters (Parame-
ter Lock). Two passwords of differing levels can be
specified to allow locking and unlocking.
1
A SYSTEM PASSWORD
This is a permanent password (maximum of eight
characters) for the entire system. The password you
specify here is valid for the PARAMETER LOCK but-
2 ) and for the CONSOLE LOCK button ( 3 ).
ton (
However, you can perform the Lock operation even
without specifying a password.
If no password has been specified, this box will indi-
cate "--FREE--". If a password has been specified,
asterisks (*) will be displayed to represent the charac-
ters of the password.
To set or change the password, click the
open the SYSTEM PASSWORD CHANGE window.
When setting the password for the first time, you will
input the same password twice for confirmation. To
change the password, you will input both the old pass-
word and the new password. By specifying a blank
entry as the new password, you can restore the state to
a condition in which no password has been set.
Note
The system password is remembered even when the power is
turned off. This means that if you forget the password, you will
be unable to defeat Parameter Lock or Console Lock except
by initializing the entire memory of the PM5D ( ➥ p.147).
Please be careful not to lose the system password.
B PARAMETER LOCK
This button sets/defeats Parameter Lock for the param-
eters selected in the LOCK PARAMETER SELECT area
4 ). If not even one parameter is selected, these but-
(
tons will be grayed-out and cannot be turned on. If the
system password has been set, clicking this button will
198
PM5D/PM5D-RH Owner's Manual
SECURITY
2
3
button to
Reference section
open the SYSTEM PASSWORD CHECK window,
where you will need to input the system password.
C CONSOLE LOCK
This button locks the console operations. If the system
password has been set, clicking this button will open
the SYSTEM PASSWORD CHECK window, where
you will need to input the system password.
D LOCK PARAMETER SELECT
If the PARAMETER LOCK button (
ters for which editing will be disabled can be selected
from the following table. As long as the PARAMETER
2 ) is on, these parameters cannot be
LOCK button (
edited.
Changes to the settings of the
SYSTEM CONFIGU-
MIXER SETUP screen and the CAS-
RATION
CADE screen
WORD CLOCK
Changes in the word clock setting
SETUP
DITHER Changes in dither-related settings
Changes to the input patch (and
INPUT PATCH
NAME) settings
OUTPUT PATCH Changes to the output patch settings
INPUT CH ON/OFF Input channel on/off operations
OUTPUT CH ON/
Output channel on/off operations
OFF
MIX channel [TO STEREO] key
MIX TO ST ON/OFF
operations
DCA [MUTE] key On operations
DCA MUTE ON
(Off operations are not included)
5
E CONSOLE PASSWORD
This is a temporary password (maximum of eight char-
acters) that is separate from the system password. The
password you specify here is valid for the CONSOLE
6 ). The method for setting or chang-
LOCK button (
ing the password is the same as for the system
password.
Hint
The Console Password is cleared when the PM5D's power is
turned off, and will return to the unset state (the box will indi-
cate "--FREE--").
F CONSOLE LOCK
This button locks the console operations. If the con-
sole password has been set, clicking this button will
open the CONSOLE PASSWORD CHECK window,
where you will need to input the console password.
4
2 ) is on, parame-
6