Output Meter Screen - Yamaha PM5D Owner's Manual

METER function

OUTPUT METER screen

This screen contains meters that show the output level of
output channels (MIX channels 1–24, MATRIX channels
1–8, STEREO A/B channels), MONITOR (L/R/C), and
CUE (L/R).
OUTPUT METER
A METERING POINT
Select one of the following as the point at which the
output level will be detected.
PRE EQ . . . . . . . . . . Immediately before the EQ
PRE FADER . . . . . . Immediately before the fader
POST FADER . . . . . Immediately after the fader
POST ON . . . . . . . . Immediately after the [ON] key
POST DELAY . . . . . Immediately after the internal
B CUE METERING POINT
Select one of the following as the point at which the
output level of the cue signal will be detected.
PRE DELAY . . . . . . Immediately before the internal
POST DELAY . . . . . Immediately after the internal
C PEAK HOLD
If this button is on, the peak level of each meter will be
held. When you turn this button off, the peak level
indication that had been held will be cleared. Peak hold
will be cleared when you change the metering point
1 ). This button is linked with the [PEAK HOLD] key
(
in the METER section of the top panel.
210
PM5D/PM5D-RH Owner's Manual
1 2 3
delay (of an output channel)
delay (of a monitor/cue
channel)
delay (of a monitor/cue
channel)
Reference section
D Meters
These peak level meters indicate the output level of
each channel. The current master level value is shown
in the box below.
If clipping occurs at any point POST EQ, POST
COMP, POST ON, POST FADER, or INSERT IN, the
∑ segment will light.
E Pair icon
This indicates the pairing status of two adjacent odd-
numbered/even-numbered channels.
4
5